Translation of original operating instructions
4
To secure the feet, insert the enclosed cotter pin into the top of the fixing unit (Fig. 5).
Fig. 5
Finally, remove the protective film from the top. If the protective film on the top is not removed, only a very low or
no heating output can be achieved.
To achieve a higher heating output, it is possible to connect multiple
modules in series with the aid of additional
pool hoses. However, depending on the pump capacity or filter system, we recommend connecting a maximum of
4 units.
Since the passage through the solar heater can reduce the flow rate within the filter circuit, it is recommended in
these cases to integrate the solar heater into the filter circuit with a bypass solution.
To do this, install a T-piece in the connection area between the pump and the solar heater to allow only part of the
circulated water to flow through the unit and the rest directly into the pool. This connection method is optimal if the
respective flow rates can be regulated and, for example, a 3-way tap is installed instead of the T-piece.
To prevent heat loss overnight, cover your pool with our solar pool liners, for example.
7. Maintenance and care
The entire connection system must be protected from freezing.
We are not liable for damage resulting from improper repair attempts or faulty installation.
Damage resulting from improper repair attempts or installation will void all warranty claims.
Regular cleaning and gentle care reduces the risk of possible malfunctions and contributes to lengthening the
service life of your unit.
Do not clean the unit with aggressive liquids, but only with a soft cloth.
Users should ensure that maintenance work is carried out by
qualified persons
and that these persons have
carefully read the instructions for installation and maintenance in the first instance.
If the unit is not used for a longer period of time, the unit should be emptied. In the event of frost, any remaining
water can cause considerable damage by freezing. Store the unit in a dry, frost-proof place. When you start the
unit up again, make sure that all seals and O-rings are in good condition. Replace damaged or worn seals.
8. Troubleshooting/recommendations
In the event of operating faults, first check whether there is an operating error or another cause that cannot be at-
tributed to a defect in the unit.
Some possible problems, possible causes and tips for their rectification are shown in the following list. If you can-
not rectify a fault yourself, please contact the customer service department or your sales point. Further repairs
may only be carried out by qualified personnel. Please be sure to note that in the event of damage as a result of
improper repair attempts, all warranty claims will be voided and we will not be liable for any resulting damage.
F
AULT
P
OSSIBLE CAUSE
R
EMEDY
1. Low flow rate.
1.
2.
3.
Dirty filter.
Blockage in the line.
Blockage in the unit
1.
2.
3.
Backwash or clean the filter.
Check the lines, avoid bends, flush thoroughly if
necessary.
Rinse the unit thoroughly.
2. Insufficient
heating output
1.
2.
3.
4.
There is no sunshine.
Unit is in the shade.
No water flowing through the unit.
The amount of water in the pool is
too large.
1.
2.
3.
4.
Sorry, you'll have to wait until it's back.
Position the unit so that it is in the sun.
Check whether the pump is working and the
heating circuit (bypass) is open
Install further units in series.
10
