T+A Elektroakustik DD 1535 R, Operating Instructions Manual

Page: 18 / 64

18
Speaker size menu
In the 'S peaker size menu ' you initially adjust the output
signals to suit the existing loudspeaker system.
To avoid the loss of any sound information in systems
where not all the loudspeakers (centre, rear and sub-
woofer) are present, the missing components must be
marked as
none in the 'S peaker size menu ' .
The corresponding sound signal is then distributed over
the channels which are present (
Downmix ).
OK
/ / / / STOP
Speaker size
Select
menu point
Change
value
Main speaker rull range
Center speaker full range
Surr. speaker full range
Back speaker 2 full range
5.1 surnd SPK Surnd+Back
Subwoofer none
Satellite high pass 80 Hz
return to Loudspeaker menu
satellite
satellite
satellite
full range
none
none
none
1 satellite
none
1 full range 2 full range
90 60 100 70 80 50
Back
Surnd
Main speaker:
Defines the size and bass capacity of the main left and
right front loudspeakers. Select one of the following
settings:
Satellit for small speakers whose bass
reproduction is necessarily restricted.
The low bass content (below the set
transition frequency) of the main channel
signals is mixed down onto the
subwoofer, if present.
full range
for larger speakers. The full frequency
range is passed on to the main speaker
channels without restriction.
Center speaker:
Defines the size and bass capacity of the center
speaker. Select one of the following settings:
none if no center loudspeaker is present. The
center channel is mixed down onto the
left and right main loudspeakers.
Satellit for small centre loudspeakers. The low
frequency bass signals of the centre
channel
(below the set transition
frequency) are mixed onto other suitable
loudspeakers and, if present, the sub-
woofer.
full range for a center speaker of about the same
size as the main loudspeakers. The full
frequency range is passed on to the
center channel without restriction.
Note:
If your system does not include a center speaker, the
main loudspeakers should be set up not too far away
from the TV set, and ideally should be arranged
symmetrically about it, otherwise it will be very difficult to
localise dialogues on the television screen.
Surround speaker:
Setting the size and bass capability of the surround
loudspeakers. Select the settings as follows:
none if no surround loudspeakers are present.
The surround channels are mixed down
onto
the left and right main
loudspeakers.
Satellit for small surround loudspeakers. The low
frequency bass signals of the surround
channels (below the set transition
frequency) are mixed by the bass
manager onto other suitable loud-
speakers and, if present, the sub-woofer.
full range if the bass reproduction of the surround
loudspeakers is very good. The full
frequency range is reproduced by the
surround
loudspeakers without
restriction.
Note:
Genuine surround reproduction is not possible without
surround loudspeakers!