OIL
To maintain your clipper in peak condition the blades should be oiled every few
haircuts. Do not use hair oil, grease, oil mixed with kerosene or any solvent
CUTTING LENGTH & CONTROL WHEEL
The control wheel allows you to gradually change the closeness of your haircut by
changing the position of the comb.
4 levels exist on the control wheel. Each level is a different hair cut level that range
between 4-16mm.
Control Wheel Level Hair Cut Length (mm)
1
4
2
7
3
10
4
16
CHARGING THE BATTERY
Before using the SY-HC32 for the first time, it must be fully discharged and then fully
charged.
1. Ensure the on/off switch is downwards.
2. Insert the plug of the mains adaptor into the power jack of the hair clipper
3. Plug the mains adaptor into a power socket.
NOTE: The indicator light will not go out when the battery is fully charged.
It takes approximately 8 hours to charge the battery. After this time the clipper must be
detached from the adaptor to avoid battery degradation and over heating.
The usage time with a completely charged battery is approx. 50 mins.
USING THE CLIPPER WHILE CHARGING
To use the SY-HC32 without the battery being charged is also possible. Connect the
adaptor to a wall outlet and to the hair clipper.
1. Connect the hair trimmer as described in the
section ”Charging the battery”.
2. Unplug the adaptor after use.
INSTRUCTIONS FOR HAIR CUTTING
BEFORE STARTING THE HAIR CUT
Check the clipper, making sure that there is no oil between the cutting blade teeth.
Turn the unit on to distribute the oil and to make sure it is running smoothly before
using. Wipe off any excess oil. This should be done before each use.
Seat the person so the head is approximately at the eye level. This allows ease of
visibility while cutting and a better control of the clipper.
