9
System Startup
Before operation can begin it is necessary to review a few details.
•
Plug one end of the supplied power cord into the upper receptacle at the rear
of the unit.
•
Next, verify that the voltage selector switch is set correctly. It is located
between the two power receptacles. The 5200 Series supports both 115 VAC
and 230 VAC at 50 ~ 60 Hz. Please confirm that the appropriate voltage (115
VAC for North America) has been selected.
•
Make sure you power on the unit using the primary power switch (located on
the rear of the unit) and secondary power switch (located on the power
supply).
0
CAUTION
Always use properly grounded
receptacles or severe damage to
your system may result. The use of a
surge protector or Uninterruptible
Power Supply (UPS) is highly
recommended.
Summary of Contents for EventCD 5200 Series
Page 1: ...Systor eventCD...
