SystemAir VH07, Installation And Maintenance Manual

Page: 6 / 44

English
4 VH
2. INSPECTION AND STORAGE
The appliances are delivered fully assembled, factory tested and ready to operate.
Any modification to the units without the manufacturer’s prior approval, shall automatically render the
warranty null and void.
The following conditions must be respected in order to maintain the validity of the warranty:
²
Commissioning shall be performed by specialised technicians from technical services approved by
the manufacturer.
²
Maintenance shall be performed by technicians trained for this purpose.
²
Only Original Equipment spare parts shall be used.
²
All the operations listed in the present manual shall be performed within the required time limits.
THE WARRANTY SHALL BE NULL AND VOID IN THE EVENT
OF NON-COMPLIANCE WITH ANY OF THE ABOVE CONDITIONS.
3. WARRANTY
4. TECHNICAL SPECIFICATIONS
4.1. OPERATING LIMITS
Water pipes
Maximum operating pressure 16 bar
Minimum inlet temperature + 5 °C
Maximum inlet temperature + 90 °C
Premises air temperature
Minimum temperature 5 °C
Maximum temperature 32 °C
Supply voltage 230 V ± 10 % / 1 ph / 50 Hz / 60 Hz
At the time of receiving the equipment carefully cross check all the elements against the shipping documents
in order to ensure that all the crates and boxes have been received. Inspect all the units for any visible or
hidden damage.
In the event of shipping damage, write precise details of the damage on the shipper’s delivery note and
send immediately a registered letter to the shipper within 48 hours, clearly stating the damage caused.
Forward a copy of this letter to the manufacturer or his representative.
Never store or transport the unit upside down. Do not stand or transport the machines with casing on end.
For storing, each carton is marked with "up" arrows. It must be stored indoors, completely protected from
rain, snow etc. The unit must not be damaged by changes in the weather (high and low temperatures).
Excessively high temperatures (above 60 °C) can harm certain plastic materials and cause permanent
damage. Moreover, the performance of certain electrical or electronic components can be impaired.