IPC/NETIPCFW-1A: User Documentation
DOC/NETIPCFW-E; V3.0
„MODE.EXE“ must be installed on the ROM-drive A: of the targte. The default
MAKEDRVX.BAT and AUTOEXEC.BAT-files delivered with the firmware are prepared
for this case.
3.
Download
the new BIOS and bootable ROM-drive into the target:
–
Connect the target COM1 port via a Null-Modem cable to the COMx-port of
your host-PC (x = port number)
–
Run the NETIPC boot loader program
–
Power-on the target in the boot-load mode (see DOC/IPC_NETIPC)
–
Enter INITx after the boot loader program prompt (x = host-PC COM port
number)
–
Wait for connection to target (Message „Target connected at .....“)
–
Enter EBIOS (or EBIOSX) to download the new Embedded BIOS
–
Wait for error-free completion (Note: takes several seconds, do never
interrupt !)
–
Enter MDRIVE_X to download the bootable MS-DOS ROM-drive A:
–
Wait for error-free completion (Note: takes several minutes, do never
interrupt !)
–
Enter QUIT to automatically update the flash-tables and leave the boot loader
program
–
Wait for error-free completion (Note: takes several seconds, do never
interrupt !)
4.
Start Up the target
with remote console/remote disk connection:
–
Run the program NETIPC Remote Console
–
Reset and Start Up the target in RUN-mode (see DOC/IPC_NETIPC)
–
Wait for connection message from INTERSVR (Note: takes some seconds, do
not interrupt !)
–
target DOS-prompt appears: enter DOS-commands, e.g. DIR A: to check correct
operation
MS-DOS is now installed on the target.
Please remember that you need a valid run-time
license for MS-DOS (not available from Syslogic).
Use MAKEDRV2.BAT instead of MAKEDRVX.BAT and MDRIVE_2 instead of
MDRIVE_X for a 1.44 MByte ROM-Drive. See also chapter 4.4 for more information about
generating a 704 kbyte or 1.44 Mbyte ROM-Disk image.
© Syslogic Datentechnik AG, CH-5400 Baden, Switzerland, http://www.syslogic.ch
36
/
45
