5
230,400
、
460,800
、
921,600
、
1,843,200 (Over 115,200 , must use MDNET-2);
Controller ID —
0001- 9999 & 01- 99;
Holidays —
366 days;
Expand Reader & Module —
SYRIS series module;
Anti Pass-Back —
Level 3 or Group Anti Pass-Back;
Speaker Output —
Built-in (max 0.2W);
Time Zone —
60 time zones;
Timer —
0-32 Timer;
Group (Application set) —
64 Application Set;
Software —
SY-SOFT-95A / SYW95A-NET-V2 / SYW95A-V3 & V2 & V832.11;
Keypad —
16key keypad;
Humidity —
10% to 95% (Non-condensing);
Operating Temperature —
--20
℃
to 70
℃
;
Power Supply —
8V to 24V DC / 0.3W to 3W;
Dimensions(mm) —
135W
×
175H
×
45D (Controller) / 122W
×
117H
×
25D
(Control Board);
Ethernet TCP/IP Module —
Optional MDNET-2;
SD Card Module —
Optional MDNSD-2 & SD Card 256M
、
512M
、
1G;
Wiegand Module —
Optional MDWIE-2;
Power Supply Module Over Ethernet —
Optional MDPOE-1;
Section 2: SY210NT Wire & Quick Installing
2.1 Required
Equipment
Power supply —12V / DC(required);
Controller and Reader connection — RS485
twisted pairs;
Controller and Computer connection — SYLINK-F via USB or RS232;
Relay connection — Relay connects with electromagnetic lock.
2.2 Selecting a Mounting Location
Select a mounting location for the unit using the following guidelines
：
z
Next to the door that is being supervised
；
z
To avoid setting controller in huge noise areas
；
z
It is recommended that setting up location should be visible for flashing card to access
easily. The height of setting location should between 45 to 50 inches to the floor.
2.3 Typical Mounting Diagram
2.4 Installing
SY210NT
1. Separate the controller and its back panel by pulling the upper side;
2. Use the back panel to mark the screw holes position on the wall;
3. Screw back panel on the wall by using four (4) screws (provided);
4. Put back controller to the back panel;
2.5 Installing the Reader Wiring Diagram
2.6 Connecting Door Lock Wiring Diagram
Door Open by power supply failure wiring diagram
Common (COM)
Normal Close (NC)
Normal Open (NO)
+
-
+12V
Electric Deadbolt
Electric Strikes
Door Open by start power supply wiring diagram
Electronic Lock wiring diagram
2.7 Connecting button to Door Open
2.8 Connecting the Door detection
2.9 Connecting
power
supply
GN
D
G
N
D
+V
+VM5
2.1
