Synway Information Engineering Co., Ltd
SMG-B Series Analog Gateway User Manual (Version 1.1.0)
Page 44
Figure 3-39 Function Key Configuration Interface
Click “Enable” to enable the corresponding function key. The gateway will use the default function
keys when the mode is set to default; and it will allow you to set new function keys when the mode
is set to user-defined. Click
Save
to save your settings into the gateway.
Note:
Phone Test is used just to see if the phone can work normally. It requires you to hang up the
phone after dialing the corresponding combination keys. Then the gateway will ring the phone. At
that time, pick up the phone and you can hear the voice prompt played by the gateway (e.g. ‘Test
successful.’)
When the
Blind Transfer
feature is enabled, set a corresponding function key in the box behind.
After you transfer a call by rapidly clapping on the hook switch, dial the set function key for
Blind
Transfer
and then the called party number. After that, hang up the call once hearing the howler
tone to let the subsequent call procedure go out of your control.
3.5.9 Dialing Rule
Considering efficiency, it is not acceptable that the gateway reports to the PBX or relevant devices
every time it receives a number. Instead, we hope that the gateway can automatically judge the
received number to see if it meets the set rule, if it is complete and if it is qualified to make
outgoing calls. Therefore, a whole dialing plan, which consists of multiple dialing rules specifying
the auto judging conditions, is required. Each dialing rule has a priority, which is used to restrict
the sequence and avoid conflict.
