Synway Information Engineering Co., Ltd
Figure 2-19 Ringing Current & Battery Feed Power Supply
Step 8: Connect the sound box or other proper sound devices.
Skip this step if there is no need to ‘monitor in real time’ or ‘play’.
Regarding how to choose proper sound devices, refer to ‘Input/output Interface’ and
‘Audio Specifications’ in
Appendix A Technical Specifications
.
Note:
The first module slot on the board must be fitted with a module should you wish
to play sound via the amplifier.
Step 9: Connect H.110 bus.
The IPC has H.110 slots on the chassis and connecting lines already fixed on them. By
installing all the necessary boards, the H.110 buses would have already been
inter-connected. Hence, no additional work by the user is needed provided each board
is correctly and properly installed.
Step 10: Boot your computer and install the driver.
Regarding driver installation, refer to
Driver Installation Manual
.
Key Tips:
unning for some time.
fety reasons,
according to standard industry requirements. A simple way is earthing with the
well as decrease in lightning resistance.
2.4
The
insta
the
oper
i.e. upon releasing the board, to wait for the hot-swap blue lamp to
light up before pulling it out from the slot.
Also note to never remove the board when it is being initialized. You must end the
application before performing a proper board insertion or extraction following the above
steps.
This restriction however, applies only when the board is under operation by a user
application.
z
As the system is expected to run for long hours unmannedly, ‘energy-saving’ mode
should be turned off for both the CPU and the HD in CMOS or WINDOWS
operating system. This is to ensure full-speed operation of the computer, or it may
lead to a drop in performance or unexpected errors after r
z
A chassis installed with voice boards must be grounded for sa
third pin on the plug. No or improper grounding may cause instability in operation
as
Precaution on Hot-swap Operation at Runtime
board should not be removed while user applications are running, or it may cause
bility problems such as system halt or application failure. The correct way is to release
bottom handle (by the red lock on the handle) and notify the application to stop
ations on the board,
SHT-16B-CT/cPCI 2.0, SHT-16B-CT/cPCI/FAX (MP3) 2.0 Hardware Manual
(Version 2.2)
Page 18
