SYNTHR SYNTHR3, User Manual

Page: 12 / 38

Page 12
SYNTHR3 Manuel V1.01 EN
ADSR VCA

ADSR envelope generator for the modulation of VCAs.

The Velocity button allows you to set the Sustain value according to the
velocity provided by the MIDI keyboard.

The Retrigger button allows one play or each note press restarts the AD
cycle.

The AutoRetrig Button allows the AD cycle to be repeated automatically
within a pressed note or active gate. The setting of the A and D values
determines the repetition frequency. To hear the effect, it is recommended
that you turn down the sustain. Decay remains active normally when
released.
* It's best to press only one of these buttons at a time, though !!!
Portamento

The adjustable portamento can be applied to either VCO1 or / and VCO2 and is
activated by the corresponding button.
OUTPUTS
VCAs
Special feature for the VCA1: It receives the Tuning fork when it is activated via the control screen (see below), and in this
case open the gain potentiometer.
The following is valid for both VCAs.

The gain control allows you to hear audio outside the envelope level. It will therefore generally be at 0 except when
listening to the pitch or playing drone.

The LFO2 potentiometer allows amplitude modulation in
addition to the gain or the envelope.

The envelope potentiometer adjusts the opening level of the
VCA.

The MIX potentiometer is used to send the output of the VCA to
outputs 1 or 2 of the synthesizer, to a mixer (line level).
WARNING: if the Gain and Envelope potentiometers are at 0 ther will be no output. Also do not forget the General Volume
potentiometer
.
WARNING: In PARAPHONIC 2 mode the VCAS have different roles: The Gain potentiometer of the VCA1 is used to adjust the
input level in the VCF2 and the Gain potentiometer of the VCA2 is used for the output level. It is preferable in this case to set it
to full. The envelope potentiometers do not act
.