Synthesis Technology MOTM-510 The WaveWarper, Assembly Instructions & Owner'S Manual

Page: 13 / 26

SYNTHESIS TECHNOLOGY PAGE 13
MOTM-510 ASSEMBLY 7/11/04
WWW.SYNTHTECH.COM
The rotary switch white 7-pin connector goes on JP2. If you look at the wires on the
connector, the 2 ‘outside’ wires are red and black. Now look at the pc board: the male
JP2 connector should have the ‘locking tab’ next to the empty R22 position. Place the
rotary switch female connector carefully on JP2,
so that the RED WIRE IS ON THE
TOP (NEXT TO VR3) AND THE BLACK WIRE IS ON THE BOTTOM, BY THE
JP2 LETTERING.
This will cause the wires to go over the top of U4, away from the
front panel.
BE SURE THAT THE CONNECTOR IS NOT ‘OFFSET’ ON JP2, THAT THE END
PINS ARE BOTH INSERTED
.
Rotate all of the front panel pots fully counter-clockwise. Locate the KNOBS . There are
7 “regular” knobs and 1 special ‘pointer’ knob. The pointer knob is for the rotary switch.
This knob goes on first, and it is somewhat tricky to align correctly.
The best way is to loosen the 2 hex screws (I have no idea why there are 2 of them),
manually rotate the switch clock-wise until it stops at the POWER position, and attach
the knob. It may take several tries to get the 2 set screws to “balance” the torque on the
knob so that the white line aligns with the 3 tick marks. Well, it’s tough for
me , at least
:(
The other 7 knobs go on the 7 pots. Place the knob on the pot shaft,
align the white line to the ‘0’ tick mark, and tighten the hex screw. The silver
part of the knob has a protective clear plastic overlay that can be removed if
desired. Gently rub with your fingernail across it and it will peel off.