SYNTHESIS TECHNOLOGY
PAGE 12
MOTM-510 ASSEMBLY 7/11/04
WWW.SYNTHTECH.COM
PART #9: FINISH WIRING TO THE PANEL
Please read the following instructions carefully. In order to neatly attach the many wires to the
front panel components, the wires are soldered in a specific order.
Now you will solder to the 8 jacks. Each jack has 3 lugs from the rear we will refer to
them as LEFT, TOP, and BEVELED. The TOP lug is for the switched contact: this is a
NC (normally closed) contact that is opened when a plug is inserted. The resistor lead
scraps placed between the TOP and the BEVELED lugs purposely shorts unused inputs
to ground. This lowers the noise and the DC offset voltage.
Solder the coax in J8 to the AUDIO OUT jack. The braid goes to the
BEVELED
lug.
The inner conductor goes to the
LEFT
lug. This is true of ALL coax wires.
Solder the coax in J7 to FULL OUT.
Solder the coax in J5 to AUDIO Z.
Solder the coax in J3 to AUDIO Y.
Solder the coax in J1 to AUDIO X. This is somewhat of a stretch, but it will reach.
Solder red/black wire in J6 to OFFSET Z. The red wire goes to the LEFT lug, and the
black wire goes to the BEVELED lug.
Solder red/black wire in J4 to the OFFSET Y jack.
Solder the orange/white wire in J2 to the OFFSET X jack. The white wire goes on the
LEFT lug and the orange wire goes on the BEVELED lug
The red/black/white wires in VR5 solder to the Bourns pot X IN. The red wire solders to
the LEFT pot lug (#3), the black wire solders to the center lug (#2) and the white wire
solders to the right lug (#1).
The orange/gray/white wires in VR6 solder to the Y IN Bourns pot. The orange wire
solders to the left lug, the gray wire solders to the center lug and the white wire solder
to the right lug.
The orange/gray/white wires in VR7 solder to the Z IN Bourns pot. The orange wire
solders to the left lug, the gray wire solders to the center lug and the white wire solder
to the right lug.
Summary of Contents for MOTM-510 The WaveWarper
Page 26: ......
