Safety Information
NuGenius/
N
User manual
4
Safety practices
This document describes the general safety practices and precautions that must be
observed when operating the NuGenius/N.
This advice is intended to supplement, not supersede, the normal safety codes in the
user’s country. The information provided does not cover every safety procedure that
should be followed. Ultimately, maintenance of a safe laboratory environment is the
responsibility of the user and the user’s organization.
Please consult all documentation supplied with the NuGenius/N before you
start working with the instrument. Carefully read the safety information in this
document and in the other documentation supplied. When setting up the
instrument or performing analyses or maintenance procedures, strictly follow the
instructions provided.
Warning notices
We use ‘Warnings’ to highlight information or instructions that
MUST
be followed to
avoid personal injury to yourself or other people in the vicinity.
For example: Switch off the mains voltage and remove the mains cord before
cleaning.
Ensure that all instrument operators read and understand the precautions listed
below.
You are advised to post a copy of the precautions near or on the instrument shelf.
The
following
precautions
must
be
observed
when
using
the
NuGenius/N.
Be sure that the voltage of the NuGenius/N instrument
corresponds to the voltage used in your laboratory.
Never remove the rear panel of the NuGenius/N instrument
without shutting down the instrument and disconnecting the instrument
power cord from line power.
The power cord must be an appropriately rated and approved cord-set in
accordance with the regulations of the country it is used in.
Do not replace the power cord with one of inadequate rating.
