Synel SY-760, User Manual

Page: 31 / 106

MAC
Back to WIFI diagram
MAC (Y/N) - If you want to confirm sending your terminal’s network MAC address to the host. Then after exit-
ing technician mode the terminal will send the host a “Hardware configuration network” message informing it
of its MAC address, IP etc.
Polling
Back to WIFI diagram
Polling (Y/N) -For polling the user will be asked to choose between Y and N. Then, the terminal will send data
to the server as per the Polling sec. definition.
Set NIC
Sets the content sensitive Network settings for WIFI.
TCP/IP Settings
Specifies the TCP/IP settings. Set by drilling down and selecting the parameters:
My MAC
Back to WIFI diagram
Confirms sending the terminal network MAC address to the host. After exiting technician mode the terminal sends the host a “Hard-
ware configuration network” message informing it of its MAC address, IP etc.
My IP Address
Back to WIFI diagram
Press line up/down to view the TCP/IP address of the terminal. Use the numeric keys to enter the IP Address.
Gateway Address
Back to WIFI diagram
Press line up/down and key-in the required gateway address.
Remote Address
Back to WIFI diagram
Press line up/down to view the TCP/IP address of the personal computer on which the SY-Server runs. Use the numeric keys.
Subnet Mask
Back to WIFI diagram
The subnet mask is the network address plus the bits reserved for identifying the subnetwork. Use the numeric keys to determine the
terminal’s subnet mask affiliation within your local net.
My Port
Back to WIFI diagram
enables connecting multiple applications via the same address. The port number selected here is the application identification number
used by the computer when communicating with the terminal. Synel applications use the default port number = 3734 (a designated
Synel port). However, you may change this according to your specific needs.