Recovery Steps
Chapter 7: Recovery Procedure
Launch the SAM-BA CDC program
600034-01A
SNAP Connect E10 User Guide
Page 44
Step 7: Launch the SAM-BA CDC program.
The
SAM-BA CDC
program is required for recovering your E10.
Note:
As mentioned previously on page 40, this program is in the
E10_Recovery.zip
file
which you should have already downloaded from the Synapse User Forum.
Once you launch the
SAM-BA CDC
program, a dialog like the one shown in
Figure 7-3
may appear. If so, just click the
RUN
button.
Figure 7-3: Running the SAM-BA CDC Program
Step 8: Make the connection.
After selecting
Run
, a dialog box like the one shown in
Figure 7-4
should appear. From this
dialog, it may be necessary to select the correct board type. (The value
at91sam9g20-ek
corresponds to the ATMEL CPU chip used inside the E10).
With the correct board type selected, hit the
CONNECT
button.
Figure 7-4: Making the Connection
If this dialog box appears,
click the
Run
button.
Select the correct board
type and click
Connect
.