SimplySNAP
Continued
SimplySNAP Quick Install Guide
Page 5
Change the Login information for the site controller:
You should next change the default username and password to a custom username and password.
Click
Config
in the left menu bar, then click the
Change Login
tab. You can change the username and
password by following the on-screen instructions.
Enter Zones, Sensors and Lights:
Now that basic setup is complete, you can begin adding lights, sensors, and switches, and group them
into zones.
Adding Zones
A zone is a grouping of related devices. They provide an easy way to group lights that you want to
control in a similar fashion. If you plan to use sensors to control light behavior, the sensors will issue
commands to specified zones. For example, you may want to group all security lights into a separate
zone from the parking lot lights. These groupings allow behaviors to be applied across multiple lights
at once.
To add a new zone:
1. Click the
Devices & Zones
menu choice in
the left menu panel, then click the
Add Zone
icon near the top of the page.
2. Enter the desired
Zone Name
and
Zone
Description
in the provided fields.
3. The
Behavior
field represents the state for
the zone when it is invoked, and can be set
to
Off
,
On
, or
Dimmer
, or to a sensor related
behavior. Zones can be reconfigured once
they’re created, so if you’re planning to use a
sensor for control, just select
On
for now.
Select the desired state, and if that state is
Dimmer
, enter the light level in the
Level
field
as a percentage from 0 to 100%.
4. Click the
Save Changes
button to save, or the
Cancel
button to exit without saving changes.
On a successful save, a blue zone panel
for the newly added zone will appear in the
content area of the
Devices & Zones
page.