Symphony Symphony 8142, Installation And Setup Manual, Page: 10 / 68

Symphony Installation and Setup Guide
2-4
2. If using a TeleSMART Keypad, set the keypad address, tamper option, and playback
volume setting by pressing and holding the [1] and [3] keys at the same time for 3
seconds; then follow the prompts. You must press these keys within 60 seconds of power-
up to set the address and/or tamper option; you can set the volume at any time after
power-up. Refer to the instructions included with the keypad.
NOTE: You must set the TeleSMART Keypad Addresses in the control panel’s
“Device Programming Mode” before they will operate.
You can set TeleSMART keypads to addresses 02-22, 25-30 (addresses 00, 01, 23, and 24 are
reserved).
Control Panel Connections
TeleSMART is powered from the control’s +12VDC keypad terminal. Connect the control’s
keypad connection terminals to the TeleSMART Control terminals as shown in the System
Interconnection Diagram in the back of this guide.
IMPORTANT: If using VISTA-50PEN or higher, you must program the following two device
addresses when programming the control: address 23 = alpha keypad; address 24 =
TeleSMART Module.
Ground Connections
Connect the TeleSMART ground terminal to a good earth ground.