Installation with MAXLINE
™
Thermostatic Mixing Valve
Installation (adjustments)
2)
To limit temperature
loosen set
screw (B), remove handle (A), loos-
en nut (D) and turn cartridge stem
(H) to desired maximum tempera-
ture (110
°
F recommended). Turn
limit stop washer (E) clockwise until
a positive stop is reached against
back of faucet. Reassemble faucet
reversing above procedure.
5
2
B
A
1
3
C
D
4
E
F
H
*
3)
For reverse operation
(in back to
back installations or when hot sup-
ply is on the right) loosen set screw
(B), remove handle (A), nut (D) and
limit stop washers (E) & (F). Turn
cartridge stem (H) 180
°
so green
marking* is facing toward front of
faucet. Adjust temperature limit
(see step 2). Reassemble faucet,
reversing the above procedure.
2
B
A
1
3
C
Note:
When setting MAXIMUM cycle time,
you MUST maintain at least 5 timing wash-
ers (C) so as not to exceed .25 gal/cyl at 60
psi (per ASME A112.18.1)
Maintenance
2
B
A
1
3
C
D
H
E
4
5
6
Note:
Faucet will operate from the full
cold position to the maximum hot tem-
perature that has been set.
2
B
A
1
3
C
1) Loosen set screw (B), remove
handle (A) and remove cycle timing
washers (C).
2) Remove nut (D), limit stop washers
(E) & (F) and cartridge housing (G).
3) Remove cartridge (H) and inspect
for debris. Replace cartridge if nec-
essary. Reassemble faucet reversing
procedure outlined in Steps 1 & 2.
1
2
D
E
F
3
G
H
1) Faucet is factory set to shortest cycle
time with 7 cycle timing washers (C).
To increase time
, loosen set screw (B),
remove handle (A) and remove
one or more of the washers.
To reduce time
, add washers.
Reassemble faucet reversing above
procedure.
MAXLINE THERMOSTATIC
MIXING VALVE
(8210CK)
COLD WATER
BYPASS TEE
FITTING
SCOT FAUCET
(SLC-6000)
TO HOT
WATER SUPPLY
DO NOT
REMOVE TAPE
TO COLD
WATER SUPPLY
FIGURE 1
SLC-6000-ML
TEMPERED
WATER LINE
COLD
WATER LINE
VALVE
OUTLET
Important:
DO NOT REMOVE tape on copper
tubing.
For applications using MAXLINE thermostatic mix-
ing valve.
1) Turn off water supplies.
2) Connect tempered water line of faucet to thermo-
static mixing valve outlet (see Figure 1 for piping
reference).
Note:
Valve and cold water bypass use compres-
sion
fittings (fittings not supplied).
3) Connect cold water line of faucet to the cold wa-
ter bypass using supplied tee fitting.
4) Connect copper tubing from cold water bypass
tee fitting to thermostatic mixing valve.
5) Connect hot water supply to thermostatic mixing
valve and cold water supply to cold water bypass
tee fitting.
6) Remove aerator from faucet. Turn handle to full
cold position. Open supply, holding down handle
for 10 seconds. Rotate handle to full hot position,
open supply and repeat above procedure. Hold
down handle and rotate from left to right to flush
lines to prevent foreign matter i.e. copper chips,
sand, stones, etc. from clogging and possibly
damaging the sealing surfaces of the faucet car-
tridge.