Page 14 of 32
P.N. 8190, Revision A1, September 2006
9.4.2 Percent Weighing
Percent weighing is carried out by defining a sample weight as 100%. The
sample weight can either be entered by the user or taken from a sample
•
Press
[Mode]
and then the
[Up]
or
[Down]
key to select Percent
weighing, “PERCENT” will be displayed
•
Press
[Enter]
to enter the function
•
Display will show, “PERCENT SAMPLE”
•
Press
[Enter]
to select the sample method
•
When “LOAD 100 %“ is shown, add the sample
•
Press
[Enter]
to set this weight to be 100%. When ready the display will
show “100%”
•
Remove the sample and place an unknown sample to display the
percentage weight
•
To set another weight as 100%, press
[Mode]
and continue as before
•
To manually enter a value to be set as 100%, press
[Up]
or
[Down]
key
when “PERCENT SAMPLE” is shown to select “PERCENT Ent Wt”
•
Press
[Enter]
to select the manually entered weight method
•
Enter the weight using the numeric entry method (see section 7.1)
•
Place unknown sample to display the percentage weight
•
To perform percent weighing with another sample press
[Mode]
and
continue as before
•
To return to normal weighing, press
[Esc]
Note:
Percentage will be displayed to the maximum number of decimal
places based on the resolution of the balance. To increase or decrease by
one decimal place, press the
[Up]
or
[Down]
key respectively.