PAGE 10
Your Symmetrikit chair can be fitted with a variety of back designs to suit
from the most simple to most complex needs. The fitting and adjustment of
these backs is described below.
6) Finger form
(for complex
needs)
Before adjusting remove the back
shell by hinging down as before.
Once hinged down pull the shell
off the lower pivot pins.
To adjust the height of the
armatures, loosen the screws at
the back of the armatures labelled
A & B. Slide into position and
retighten the screws.
To alter the position of the
Armatures loosen all four Adjuster
Buttons (arrowed). The armature
can then be moved in any
direction required to support the
user. Once in the correct
position tighten the buttons using
the spanner provided. Note the
number beside each button
against the settings chart. Also
take note of the position of the
armature on the cross slide scale. This should be read from the
outer most edge of each silver bracket.
If required armatures can be
simply added or removed.
Lift the backrest cushion to allow
access to the uprights (not shown
for clarity).
With the clamp screws tight the
armature bracket should be twisted
so that it no longer over laps the up
right. It can then be removed
forwards. Reverse this to add more.
X 2
X 2
Summary of Contents for Large
Page 23: ...PAGE 23 NOTES ...
