Symbol LS 6000i, Product Reference Manual

Page: 27 / 205

LS 6000i Series Product Reference Guide
2-4
4. Plug the other end of the power supply into an
AC outlet.
5. Connect the other end of the interface cable to
the scanner.
Figure 2-2. Plugging Connector into Scanner
6. Set the LS 6000i to communicate with your
particular POS terminal by scanning the
appropriate bar code(s). Depending on your
terminal, these are located either in
Chapter 5,
Programming , or the Synapse Interface
Guide .
7. Power up the host terminal. Ensure that the
scanner driver port is enabled by following the
terminal instructions.
8. Verify that the scanner is successfully reading
bar codes and transmitting their content to the
host terminal.
See Troubleshooting on page 4-5 if you are having
problems after completing these steps.