33
Architecture
About management and detection architecture
In blocking mode, all network traffic is examined by the Network Security
detection software before it enters your network, and is blocked if malicious.
When a protocol anomaly event or an event matching an enabled signature is
detected, the offending packet is dropped. For TCP/IP traffic, a reset is sent to
the TCP connection.
In alerting mode, the Network Security detection software still analyzes all
packets as they enter your network, but does not prevent an intrusion attempt
from proceeding. You can configure a non-blocking protection policy to send a
reset and an alert, based on event ID.
With only alerting enabled under in-line mode, there is no risk of inadvertently
blocking legitimate network traffic. The advantage of in-line alerting mode over
operating in passive mode is that you can enable blocking with a single
mouse-click from the Network Security console. You don’t need to halt network
traffic while changing cabling and configuration to switch between in-line
alerting and blocking modes.
About fail-open
When you configure in-line mode on the Symantec Network Security 7100
Series appliance, you place the in-line interface pair directly into the network
path. If the appliance or one of those interfaces has a hardware or software
failure, all associated network traffic is blocked. You can avoid this risk with the
addition of the 2 In-line Bypass unit
or
4 In-line Bypass unit, custom fail-open
devices available from Symantec specifically for the appliance. These devices
provide the fail-open capability, allowing your network to stay up while you
make repairs.
At this time, the bypass units are only available for copper interfaces. There is
currently no fail-open solution for the fiber interfaces of the appliance model
7161.
Summary of Contents for 10268947 - Network Security 7160
