10.Inspection and maintenance before riding
23
THROTTLE VALVE HANDLE CLEARANCE ADJUSTMENT
Correct clearance allows throttle vale handle to rotate
2~6mm.
Loosen the lock nut first, then turn the adjust nut to
adjust. Tighten the lock nut securely when finished.
Check Items:
1. Check throttle valve cable to see if it can be moved
smoothly from a closed position to a wide open position.
2. Rotate steering handle from side to side to check if the
throttle valve cable is interfered.
3. Check to see if the throttle valve cable is obstructed by
other cables preventing it from being operated smoothly.
WIRING RUBBER CAP
The rubber caps are used for protecting the wires of the
wiring. Check the caps frequently for settling at right
position.
Do not direct water under pressure against the wiring or
use brush when washing motorcycle. If the wiring is very
dirty. Use cloth to scrape it.
DRIVE CHAIN
The drive chain will be elongated and slackened as the
using time passed. So it is necessary to be inspected and
adjusted.
<Drive Chain Inspection>
The drive chain check lie under drive chain center, the
slack of the chain should be 10~20mm.
Stand the motorcycle with main stand upright. Turning
the rear wheel, check the drive chain for free operation
and noise.
Adjust the drive chain if there is any abnormality.
<Drive Chain Adjustment>
1. Loose the rear wheel axle nut.
2. Turn the adjusting nut for adjustment. Tighten the axle
nut after adjusted.
CAUTION:
The right and left adjuster must be adjusted to
same scale.
Clean and lubricate the drive chain frequently.
Adjust nut
Lock nut
2~6 mm
10~20mm
Axle nut
Adjuster
Scale
Rubber cap
Rubber cap
Check
points
Summary of Contents for Wolf Classic 150
Page 1: ...OWNER S MANUAL...