Sym Quad Lander 300, Service Manual

Page: 8 / 244

To this chapter contents
1. GENERAL INFORMATION
Service Precautions
y
Always use with SANYANG genuine parts and
recommended oils. Using non-designed parts for
SANYANG ATV may damage the ATV.
y
Special tools are designed for remove and install
of components without damaging the parts being
worked on. Using wrong tools may result in parts
damaged.
y
When servicing this ATV, use only metric tools.
Metric bolts, nuts, and screws are not
interchangeable with the English system, using
wrong tools and fasteners may damage this
vehicle.
y
Clean the outside of the parts or the cover before
removing it from the ATV. Otherwise, dirt and
deposit accumulated on the part's surface may
fall into the engine, chassis, or brake system to
cause damage.
y
Wash and clean parts with high ignition point
solvent, and blow dry with compressed air. Pay
special attention to O-rings or oil seals because
most cleaning agents have an adverse effect on
them.
y
Never bend or twist a control cable to prevent
unsmooth control and premature worn out.
y
Rubber parts may become deteriorated when old,
and prone to be damaged by solvent and oil.
Check these parts before installation to make
sure that they are in good condition, replace if
necessary.
y
When loosening a component which has different
sized fasteners, operate with a diagonal pattern
and work from inside out. Loosen the small
fasteners first. If the bigger ones are loosen first,
small fasteners may receive too much stress.
y
Store complex components such as transmission
parts in the proper assemble order and tie them
together with a wire for ease of installation later.
y
Note the reassemble position of the important
components before disassembling them to
ensure they will be reassembled in correct
dimensions (depth, distance or position).
y
Components not to be reused should be
replaced when disassembled including gaskets
metal seal rings, O-rings, oil seals, snap rings,
and split pins.
1-3