19
INSPECTION AND MAINTENANCE OF BATTERY
•
This scooter is equipped with a maintenance-free type battery, so it is unnecessary to check and add
electrolyte. Have your scooter checked by SANYANG Authorized Dealer or Franchised Dealer should any
abnormality is found.
﹙
Cleaning of battery terminals
﹚
Remove the battery terminals and clean if there are dirt
and corrosion on them.
Battery removal procedures are as follows:
Turn ignition switch “OFF”, then open the battery cabinet door,
and remove negative cable screw firstly and disconnect the
negative cable. Then, remove positive cable screw and positive
cable.
CAUTION:
•
Clean the battery posts with warm water if the posts are eroded and have some white powders on
them.
•
If there is an obvious erosion on the terminals, disconnect the cables, then clean the erosion off with
a steel brush or a piece of sandpaper.
•
Install battery cable after cleaning and apply a thin coat of grease on the terminals.
•
Install battery in reverse order of removal.
•
This scooter is equipped with a maintenance-free type battery, so it is unnecessary to check and add
electrolyte. Have your scooter checked by SANYANG Authorized Dealer or Franchised Dealer should any
abnormality is found.
CAUTION:
•
This is a closed type battery. Never remove the caps.
•
In order to prevent electric leakage and self-discharge when the battery sits idle for long periods.
Remove battery from scooter, store it in a well- ventilated and dimly lighted place after the battery
has been fully charged. Disconnect battery’s negative cable if the battery is still kept on the scooter.
•
If the battery needs to be replaced, replace with a same closed-type battery (Maintenance-Free).
Negative
Positive
10.Inspection and Maintenance Before Riding
