Cordless Telephone Operation
9
Preparing for Use
1.
Place the
HANDSET
on the
BASE UNIT
for 12 hours.
2.
After 12 hours, remove the
HANDSET
from the
BASE UNIT
.
Before you can use your cordless telephone, you must charge the HANDSET for
12 hours. Failure to do so will require more frequent charging of the BATTERY
PACK.
NOTE:
Depending on the frequency of use, once the
HANDSET
is fully charged, it remains
func-tional for approximately 6 hours of continuous use and approximately 6 days when the
HANDSET
is off the
BASE UNIT
in STANDBY mode.
Placing Calls
1.
Press the
TALK
button. The
HANDSET
IN
USE LED indicator and the
BASE UNIT
IN
USE/CHARGE LED indicator will light up.
2.
Listen for a dial tone.
3.
Dial the phone number.
4.
When you have finished your call, either
press the
TALK
button or place the
HAND-
SET
on the
BASE UNIT
. The
HANDSET
IN
USE LED indicator will turn off and the
BASE UNIT
IN USE/CHARGE LED will light
up to indicate that the
HANDSET
is
charging.
NOTES:
1.
During a telephone conversation, press the
VOL (VOLUME)
button to select the
desired
HANDSET
receiver volume level from MAXIMUM, HIGH, MEDIUM, or LOW.
Press the (
+
) button to increase, or press the (
-
) button to decrease the volume level.
A double “beep” sound will be heard when the (
+
) or (
-
) button is pressed further after
the MAXIMUM or the LOW volume level.
2.
The
BASE UNIT
does not have a ringer and does not ring when receiving an incoming
call.
3.
If you are too far away from the
BASE UNIT
, the
HANDSET
emits “beep” sounds to warn
you that the background noise level is too high for proper communication between the
HANDSET
and the
BASE UNIT
. When you hear this sound, you should move closer to
the
BASE UNIT
to reduce the noise level. Otherwise, the call will automatically cut off.
VOL