Changeover contact is permanently active (and does not switch)
•
The changeover contact activation time has been set to “00” and is in toggle mode. Each valid
access to the code lock changes the changeover contact switch position.
•
The bypass code has been entered. Enter the bypass code once again to go back to normal
mode.
AUX output does not switch
•
When the AUX output is assigned one of the functions to as described in section 8. p),
make sure you also set a switching time (see section 8. q). In addition, toggle mode applies
to the AUX functions and .
•
Neither the master transponder nor user transponders can be used to activate the AUX output.
Master code cannot be changed
•
For security reasons, you cannot use a master transponder to start the programming mode
in order to change the master code. You can start the programming mode by entering the old
master code twice with a keypad, as described in section 8. b).
Resetting to factory defaults does not delete any transponders and user codes
•
This is normal. If you want to delete transponders and user codes, follow the instructions in
section 8. g).
Buttons are triggered inadvertently or not at all
•
Clean the front panel of the code lock and wipe the exterior dry.
LED lights up red instead of blue
•
The red LED indicates that the AUX output is enabled. When the AUX output is disabled, the
LED lights up blue (standby).
77
