User Manual PILOT
touch
May 2016
Page 11 of 20
4.4.1 Copying Infrared Signals
Every key can store up to 4 IR signals. The signals will be sent in the same order as they have been
copied. The time between the signals is 0.5 s.
1.
Select “Infrared” and confirm with “OK”
Note
The selected key can be change at any time by touching the new key. The current selected key
is marked with a white square.
2.
Now you can choose between Teach-in IR, Test an
already stored macro, delete all stored IR signals or
analyze the signal of the remote control.
Note
Most IR signals use a carrier frequency between 38 and 40 kHz. If you realize problems with
the learned IR signal you should analyze the signal first to set the right frequency. There are
also a few systems that use a frequency of 455 kHz.
You can also test the stored macro just by pressing the key.
3.
Select “Analyze remote“ and confirm with “OK“
Now you are asked to send a signal from the remote
control. Please position the remote control in front of
of the PILOT touch as shown below and press any key.
The displayed frequency will then be changed in case it
is different.
