10
V2.4
Network Settings
These RS232 commands allow setting or retrieving the network settings:
Command
Description
SET DHCP 0
Disable DHCP mode
SET DHCP 1
Enable DHCP mode
SET HIP xxx.xxx.xxx.xxx
Set (4K Switcher) Host IP address to xxx.xxx.xxx.xxx
SET NMK xxx.xxx.xxx.xxx
Set (4K Switcher) Subnet Mask to xxx.xxx.xxx.xxx
SET RIP xxx.xxx.xxx.xxx
Set Default Gateway IP address to xxx.xxx.xxx.xxx
SET TIP zzzz
Set TCP/IP port to zzzz
GET DHCP
Get the DHCP setting
GET HIP
Get the Host IP address
GET NMK
Get the subnet mask
GET RIP
Get the Default Gateway IP address
GET TIP
Get the TCP/IP value
GET MAC
Get the MAC address
When shipped from SY, the default IP settings are:
Host IP Address
192.168.1.239
Subnet Mask
255.255.255.0
Default Gateway IP Address
192.168.1.1
TCP/IP Port
23
DHCP
Off
The IP settings can be used to either gain access to the built-in web interface or as a control
input for sending the same commands as given for the RS232 port through an IP v4 connection.
Please note that the carriage-return character is still required for every command sent over IP
to the SY-MSUHD-88.
