SY-HDBT-231
V1.0
3
Rear Panel
Name
Description
EDID Switches
Selects the desired EDID mode – (applied to both inputs)
Audio Out
De-embedded stereo analogue audio out from the selected input
HDMI 1 & HDMI 2
HDMI signal input connectors
HDMI OUT
Local HDMI output connector
HDBT1, 2 & 3
HDBaseT outputs to remote receivers – Provides PoC
RS232
Pass-through RS232 to all 3 HDBT ports – Receive from HDBT 1 only
RS232-CTL
RS232 control for the SY-HDBT-231
IR Out
IR output from HDBT ports – Summed output
IR In
IR input to HDBT ports – Broadcast to all
48V
48V DC power supply input
Using the SY-HDBT-231-70 / 100
1.
Connect the two HDMI inputs to any HDMI sources. Connect to the HDBaseT and Local
HDMI outputs as needed. The HDBaseT outputs should be connected to the receivers
using Cat6 cabling to ensure the best signal quality over the maximum cable length.
2.
Connect the 48V power supply.
3.
Use the SELECT button to switch between the two HDMI inputs.
Using the Auto-Detect Mode
Hold down the SELECT button until the AUTO LED lights up (~3S) – Auto-detection enabled.
Hold down the SELECT button until the AUTO LED goes out (~3S) – Auto-detection disabled
.
When in Auto mode, the unit will automatically switch to a newly active HDMI input and will fall
back to the other active input if no signal on current selection detected.
When in Manual mode (Auto off), either input can be selected regardless of being active or not.
