Always turn the machine on and let it perform booting up
cycle before connecting pressurised air line.
™
1
2
3
4
Secure quick connect fitting to the airline using supplied hose clamp
and connect to male inlet fitting (Located on the back of the
machine).
Connect the plasma torch lead to the torch socket and secure using the
retaining nut. (Ensure to tighten)
Connect the ground cable connector to the positive terminal and turn
clockwise to lock in place.
Plug machine into a suitable mains power supply or generator and
turn on using the ON/OFF switch (Located on the back of the machine).
1
2
3
4
Protect your eyes and body. Always use an approved
welding helmet/googles and filter lens shade #5 and
wear protective clothing.
Push safety switch
away with finger and
pull trigger.
System will adjust air pressure
then start pilot arc after 2
seconds.
Release trigger to stop arc after
cut and to start the air cooling
cycle (15 seconds).
Pull then release trigger to stop
cooling cycle prematurely.
Always let machine perform
cooling cycle after long cuts as
you may damage the torch
cartridge.
Place standoff guide, drag tip, or position torch tip 3-9mm off the
metal at 90 degrees and pull the trigger. Once the cutting starts
begin to slowly move across the workpiece
i
WARNING!
The pilot arc can cause serious burns - Never
engage trigger switch when torch tip is directed towards
the eyes, face or body of yourself or others.
Adjust your speed so that sparks are coming from the backside of the
metal. If sparks are not visible at the bottom of the metal, you are not
penetrating the metal. This can be caused by moving too fast, insufficient
amperage or too thick of material for the rated capacity. At the end of the
cut angle, your torch past 90 degrees to completely sever the metal.
NOTE: Cut quality is highly
dependent on setup and
the cutting parameters
such as alignment with the
workpiece, torch standoff,
cutting speed, gas
pressures, and operator
ability.
FOR CONSUMABLES & SUPPORT GO TO WWW.SWSWELDING.COM.AU
START UP PROCEDURE
