Manual Version 1.0
13
TORCH TRIGGER MODES
2 Step -
Pull and hold the trigger to weld release to stop welding.
4 Step -
Pull trigger for 1 second then release the to start welding pull trigger to activate
last value welding parameters. Release to stop welding.
4 Step Special -
Pull and hold trigger for first welding parameters, release for main
welding parameters, pull and hold for last welding parameters.
Tack -
Set the welding on time in seconds for consistent tack welds. (This parameter can
be found in the MIG welding mode screens parameter box once selected)
The torch trigger modes can be used to change the welding amperage and voltage
while welding. This can be useful for when welding aluminum to use higher values
at the start of the weld and lower at the end as the metal heats up preventing burn
through and as a crater current.
