Swiwin SW Brushless Series, Operation Manual

Page: 8 / 14

cooling the unit will render damage and will void the warranty.
To shut down the turbine
1. Lower the stick to minimum
2. Lower trim to minimum
3. The motor will shut down and initiate a cooldown sequence by turning on the starter motor to an RPM defined in
motor parameters. This cool down speed is determined in cooling menu of ECU setup. The default cool down speed
is 7000 rpm. The motor turns continuously until a safe temperature is reached. Please note that it is normal with
new ECU releases for the starter to spin continuously until the motor is cooled. Previous firmware releases spun
the motor intermittently to save the life of the motor.
4. Turn off the fuel
5. Turn off power to the controller
6. Turn off power to your radio
ECU
The SWIWIN ECU was designed from the ground up and is based on 32 bit microprocessor functionality and designed
specifically for SWIWIN Turbines.
The ECU offers the following benefits:

Data Logging Auto start Automatic Restart

Color Screen visible in direct sunlight

Configurable thrust curve with very fast throttle response

Telemetry function

BUS input
ECU/Motor Electrical Connections
Do not exceed these voltages!
Receiver voltage
：
5-8.4V(4S Nimh or 2S Life or 2S Lipo)
Power voltage
：
11.1V (3S Lipo)