Learn RC
This menu is to train the transmitter to the ECU.
Max – Throttle up, trim up
Idle – Throttle down, trim up
Min – Throttle down, trim down
FailSafeTime – set fail safe time in seconds
[BUS] Throttle cha – setup throttle channel if use BUS Mode input
[BUS] Switchcha – setup switch channel if use BUS Mode input and
switch startup function,if turn on this function ,ppm input will
invalid, need use BUS mode for input
TelemetryMode – set telemetry mode 1/1 for single engine mode
Starter
Eject Time – sets the time for a reverse voltage pulse to disengage
the starter.
Eject Voltage – sets the eject voltage in order disengage the clutch
on startup
Run Voltage – Sets the voltage for the starter during startup
RPM Stable – rpm adjust rate of starter
Engine Cooling
Sets the cooling rpm after shut down or when starter is manually
run using test functions.
*Please note that following a failsafe failure or flameout that the
motor will not automatically enter a cool down sequence. This is
because the ECU has no way of knowing the status of the motor
whether flame out, crash or other.
Summary of Contents for SW Brushless Series
Page 13: ...Spec ...
