− Settings −
103
12
Settings
12.1
Default settings
Language: German
SMS receive centre 1:
0622 100 000*
Handset name:
DCT4073
SMS receive centre 2:
Empty
Handset ringer volume: 3
SMS send centre 1:
0622 100 000*
External ringing melody: 3
SMS send centre 2:
Empty
Internal ringing melody: 1
SMS receive signal:
On
Base ringer volume:
3
Low battery warning signal: On
Base ringing melody:
2
Out of range warning signal: Off
Receiver volume
3
Key beep:
On
PIN: 0000
Key lock:
Off
Dialling mode:
Tone (DTMF)
Automatic answer:
On
Recall time 1 (standard): 90 ms
Time / Alarm:
Off
Recall time:2
250 ms
Pause: 3
seconds
* Service centre Swisscom"
Answering machine
OGM:
OGM1
Answer delay:
6 Rings
Memory:
Empty
Answer VOL:
5
Security code:
000
Time / Day stamp:
Saturday /
12:01 pm
Answer Mode:
ON
The handset and base station can be reset to their default settings.
Refer to Section 7.3 for the procedure to do this.
Please note that, on resetting the default settings, the entries in the phone book, calls
list and phone numbers in the redialling list are deleted!
12.2
PIN code
The PIN code can contain up to four digits. The default setting of the PIN code is 0000".
If you change a PIN code, keep a note of the new PIN code in a safe place. Many of
the telephone functions cannot be used without the PIN code!
12.3
Recall times
The recall time determines the duration of a tone which is produced by pressing a button on the
telephone. In order that your telephone system can function properly, it may be necessary to adapt
the recall time (flash time).
There are two recall times available for selection in order to use functions in private branch ex-
changes or supplementary services offered by your telephone network provider (also refer to Sec-
tions 2.7 and 2.9). You can select between a recall time of 90 ms (default setting) and 250 ms. The
procedure to set the recall times is described in Section 7.3 (also refer to Section 12.1).
12.4
Handset name
An individual name can be programmed for the handset.
It can comprise up to 10 characters.