5、Scanning
6、Control
13
Exit:
Return to Main Menu.
Contrast:
Adjust the contrast of the display.
Brightness:
Adjust the brightness of the display.
Chroma:
Adjust the saturation of the display.
Sharpness:
Adjust the sharpness of the display.
Backlight:
Adjust the backlight of the display.
Exit:
Return to Main Menu.
Scanning:
Scan mode setting.
Zoom Mode:
Zoom in on the selected area.
Flip Mode:
Flip mode setting.
Odd/Even Frame:
Select Odd/Even Frame mode.
Exit:
Return to Main Menu.
GPI Control:
Enable GPI control.
GPI 1Pin~GPI 6Pin:
Assign functions to the GPI terminals.
The GPI pins can be setted to the down below functions:
SDI1, SDI2, SDI3, SDI4, 4×SDI(2-SI)、4×SDI(SQ), HDMI, Red Tally, Green Tally, Yellow Tally ,Time Code,
Freeze Frame, WFM Type, WFM Single Line, UMD, Marker, H/V Delay, Waveform, Audio Bar, Zebra,
Vector, Low Latency Mode, Histogram, Lissajous, Focus Assist.
Scanning
Exit
Scanning
Zoom Mode
Flip Mode
Freeze Frame
Odd/Even Frame
Panel Fit, H Fit(4K), Native
OFF, Top Left, Top, Top Right,
Left, Center, Right, Botton Left,
Bottom, Bottom Right
OFF, ON
OFF, Top Half, Bottom Half, Full
OFF, Odd Mode, Even Mode
Contral
Exit
GPI Control
GPI 1Pin
GPI 2Pin
GPI 3Pin
GPI 4Pin
GPI 5Pin
GPI 6Pin
Tally Setting
Tally Position
F1
F2
F3
UMD
UMD Color
UMD Position
UMD Size
UMD Blending
Display Type
RS485 Address
Baud Rate
Source ID
OFF, ON
HDMI
SDI1
SDI2
SDI3
SDI4
<4xSDI(2-SI)>
OFF, ON, Blinking
Top, Bottom
Audio Bar
Vector
Lissajous
OFF, ON
White, Red, Green, Blue, Black, Gray
Top, Bottom
Large, Small
OFF, LOW, HIGH
Source ID, UMD
1
115200,8,n,1
CAMERA 1
