Copyrights by
Ausgabe 0.4
Swissphone Telecom
30.11.2005
Fälmisstr. 21 CH-8833 Samstagern
Art. Nr. 0343130
Seite 8/10
Alarm timer (only applicable to "Voice" and "Memo" models)
If the alarm timer function is activated through the programming software, then the
time passed since the last alarm was received is displayed on the LCD. The LED and
the address arrow flash. The alarm timer is reset by acknowledging the alarm.
On the right side, both 7-segment character places will count the
seconds. While during this, the seconds will flash during each change.
The flashing separates the seconds display from the 7-segment LED on
the left, which counts the minutes. A total of 60 minutes (59:59) can be
shown on the display in this mode.
After 60 minutes have passed, the time will only be displayed in hours and
minutes. The arrow and LED continue to flash.
The time is not displayed anymore once the counter overflows (when min. > 12 hours),
only the LED for incoming calls flashes now.
Choosing profiles / channels (only applicable to "Voice" and "Memo" models)
Push the
SELECT
key (1) until the 4-digit, 7-segment character display flashes. Then
enter the Profile Setting with the
EXECUTE
key (2). The first profile is now shown (the
first channel). You may switch between the pre-set profiles by pushing the
EXECUTE
key (channels).
If the desired profile is shown, pressing the
SELECT
key (1) gives you the option to
activate an extra profile. The extra profile is activated when
is shown and deactivated
when is shown.
If the desired channel is shown, confirm your selection by pressing the
SELECT
key
(1).
In idle state, the receiver always displays the active profile or the active reception
channel.
