Copyrights by
Ausgabe 0.4
Swissphone Telecom
30.11.2005
Fälmisstr. 21 CH-8833 Samstagern
Art. Nr. 0343130
Seite 6/10
Loud alert
Incoming calls are signalled simultaneously with a call signal and a vibration. In
addition, the LED in the upper left corner starts flashing. Following these signals, you
will hear the spoken announcement via the loudspeaker (not applicable to the "Tone"
model).
Minibeep
Incoming calls are first indicated by the vibrator, and then with short beep tones. The
LED in the upper left corner also flashes. Following these signals, you will hear the
spoken announcement (not applicable to the "Tone" model).
Silent alert
Incoming calls are signalled only by the vibrator. There is no acoustic alarm, and no
spoken announcement is heard.
Monitor
(Only applicable to the "Voice" and "Memo" models)
In this operational mode, you can hear everything that is spoken over the set radio
channel. Calls addressed to you will be signalled "acoustically". If you wish to switch off
the continuous monitoring / listening operation, select one of the acoustic symbols with
key (1), and confirm this with key (2).
((i))
Remark
Pagers with the voice memory (Memo) will always record the spoken message when the
programming of the voice memory has been assigned to the appropriate address and the
alarm type has been set to "Voice" or "Tone & Voice" status. In monitor mode, a spoken
message will only be recorded if the proper address has been activated. Via programming,
the voice memory can be assigned either a fixed or dynamic mode. The total recording time
can be set to 8x30, 6x40, 4x60, 3x80 or 2x120 sec. Please find more information in the
Programming Manual.
Volume
(only applicable to "Voice" and "Memo" models)
The volume for voice messages can be set to one of 4 levels. The volume of the call
signal is not affected by this parameter. With key (1), select the volume symbol.
Using key (2), you can now select the desired levels 1, 2, 3 or 4, which you can then
acknowledge with key (1). Level 1 is the quietest and Level 4 the loudest. Level 3
corresponds to the nominal volume.
New message
Incoming calls can be signalled via the loudspeaker and the vibrator together,
depending on the operational mode. In addition to the complete
alerting, you can also listen directly to the incoming voice message (not
applicable to the "Tone" model). Depending on the transmission type,
several seconds may elapse between the wake tone and the voice
message. During this period, no commands can be issued to the
receiver. After the voice message plays, the LED (light display) in the
upper left corner also blinks.
In the display, you will see the names, the address (only "Voice" and "Memo") and an
arrow indicates one of the 4 display fields. At a glance, you see which alarm address
was triggered.
If an occupied address or call is not acknowledged, then a reminder call will
periodically be issued (at pre-set time intervals). This can either be indicated
