Copyrights by
Ausgabe 0.4
Swissphone Telecom
30.11.2005
Fälmisstr. 21 CH-8833 Samstagern
Art. Nr. 0343130
Seite 3/10
((!))
WARNING: Keep batteries out of reach of children under 3 years old
The Swissphone RE629 receiver is automatically switched on when the battery is inserted
A test is done whilst all loads in the device are activated temporarily. The device then is
ready to receive messages.
((i))
NB:
For optimal indication of the battery or re-chargeable battery levels, the type of re-
chargeable battery installed has to be set using the operation in the device (see chapter:"
Selecting the type of re-chargeable battery"). The indication will be shown correctly after at
least one full charge-/re-charge circle.
Die Anzeige stimmt erst nach einem vollständigen Entlade/Ladezyklus genau.
Inserting the battery
To insert the battery, proceed as follows:
1) Open the battery compartment by pressing down the tongue into the rear panel and
pulling out the battery cover sideways. If necessary, use a coin as a tool.
2) When inserting the battery, please observe the correct polarity and the marking of the
cells. Insert the supply source with the negative pole (-) leading, so that the spiral spring is
slightly compressed, and then simply lay the battery into the battery compartment.
3) Replace the battery cover and push it in until the tongue latches into the rear panel of the
housing.
Automatic switch-on
After inserting the battery in the battery compartment, the receiver switches on automatically.
A self-test of the, the LED, the display and the vibrator is started, and is completed by a
control sound (beep).
The receiver is switched on and its operational status can be read from the display.
The battery status indicator shows the approximate energy level of the power source.
((i))
If a self-test does not take place, check the polarity of the power source, or place the
pager into a charger. Various charging units are available (LG Standard, LGRA Professional,
ALGRA Professional).
Switching off
Switch off your receiver by
simultaneously
pressing the keys
SELECT
(1) and
EXECUTE
(2) for
about 4 seconds. In the display the frame of the battery symbol flashes and an clicking
sound can be heard until the Display is cleared. The pager is now switched off.
Switching on / keys
If the receiver is switched off, you can switch on the pager operation by
simultaneously
pressing both operating keys
SELECT
(1) and
EXECUTE
(2).
Select (1)
Execute (2)
