49
Operating with other devices
Gigaset CX100-150isdn / englisch / A31008-X150-G101-1-7619 / devices.fm / 20.01.2004
Operating with other devices
Gigaset M101 Data and M105 Data data modules
The Gigaset M101 Data with V24 interface and the Gigaset M105 Data with USB
interface provide you with a cordless connection between your PC and the base station,
e.g., for Internet access.
For installation, see the installation instructions on the CD-ROM provided with the data
module.
Gigaset Repeater V2
You can increase the range of your handsets with the Gigaset Repeater. You can operate
up to six repeaters on your base. To ensure the repeater is installed correctly, repeater
mode must be activated on the base.
Activating/deactivating repeater mode
You can use this function to activate and deactivate repeater mode.
When the phone is supplied the repeater mode is deactivated.
Registering a repeater
Precondition:
Gigaset Repeater has been deactivated (mains cable unplugged).
1. Press the registration/paging key on the base station for about 3 seconds. The key
flashes.
2. Plug the Gigaset Repeater into the mains. The LED on the Gigaset Repeater flashes.
After a short while the LED is permanently illuminated. This indicates that
registration has been completed and the repeater is ready for use.
Further information is available in the operating instructions for the Gigaset Repeater.
MENU
Press the display key to open the menu.
s
Base Settings
OK
Select the menu item and confirm.
s
Settings
OK
Select the menu item and confirm.
~
OK
Enter system PIN if required (page 30).
s
System settings
OK
Select the menu item and confirm.
s
Special function
OK
Select the menu item and confirm.
s
Repeater Mode
OK
Select the menu item and confirm (
‰
= activated).
OK
Press the display keyto confirm the prompt.
a
Long
press (back to idle status).
i
Check that there are no other base stations registering in the vicinity of
the Gigaset Repeater during this procedure.
