13
First steps
Aton CL113 Duo / Swisscom en / A31008-M2202-F151-1-2X19 / starting.fm / 07.07.2011
V
e
rsion 4, 16.0
9
.2005
Initial charging and discharging of the batteries
The correct charge status can only be displayed if the batteries are first fully
charged
and
discharged.
¤
Charge the handset in the base for
6 hours
.
¤
After charging, remove the handset from the base and only replace it when the
batteries are
fully discharged
.
If you have any questions about using your phone, please read the tips
on troubleshooting (
page 45) or contact our Customer Care team
Please note
The handset must only be placed in the designated Aton CL113 base or charger.
6h
Please note
u
The handset is pre-registered with the base. If you have purchased a
model
with multiple handsets
, all handsets will already be registered with the
base. You do not need to register the handset again.
However, if a handset is not registered with the base (
Register handset
or
Place handset into base
flashes on the display), please register the handset
manually
u
After the first battery charge
and
discharge, you may place your handset in
the charger after every call.
u
Always repeat the charging and discharging procedure if you remove the
batteries from the handset and reinsert them.
u
The batteries may warm up during charging. This is not dangerous.
u
After a while, the charge capacity of the batteries will decrease for technical
reasons.
