Swisscom Aton CL113, User Manual

Page: 38 / 59

36
Using the handset as an alarm clock
Aton CL113 Duo / Swisscom en / A31008-M2202-F151-1-2X19 / registr_sett.fm / 07.07.2011
V
e
rsion 4, 16.0
9
.2005
Using the handset as an
alarm clock
Prerequisite: The date and time have
already been set (
¢
page 15).
Activating/deactivating the
alarm clock
§Menu§
¤
Alarm Clock
¤
Activation (
³
= on)
After you activate the alarm clock, the menu
for setting the wake up time opens automat-
ically.
The
¼
icon and wake up time are shown on
the display.
A wake-up call is signalled on the display
(
¢
page 3), with the selected ringer volume
and melody (
¢
page 40). The wake-up call
sounds for 60 seconds. If no key is pressed,
the wake-up call is repeated twice at five
minute intervals and then switched off.
During a call, the wake-up call is only sig-
nalled by a short tone.
Setting the wake-up time
§Menu§
¤
Alarm Clock
¤
Wake up time
~
Enter the wake up time in hours
and minutes, then press
§OK§
.
Deactivating the wake-up call/
repeating after a pause
(snooze mode)
Prerequisite : a wake-up call is sounding.
§Off§
Press the display key. The wake-
up call is deactivated.
Or
§Snooze§
Press the display key or any key.
The wake-up call is deactivated
and then repeated after 5 min-
utes. After the second repetition
the wake-up call is deactivated
completely.
Using multiple handsets
Registering handsets
You can register up to four handsets on your
base.
Each additional handset must be regis-
tered with the base in order for it to work
properly!
Registering a handset
(Aton CL113) to the base
Aton CL113
You must manually register the handset on
both the handset (1) and the base (2).
Once registration is complete, the handset
returns to idle status. The handset's internal
number is shown on the display, e.g.,
INT 1 .
If not, repeat the procedure.
Registering other handsets
You can manually register handsets for other
devices with GAP functionality as follows.
1) On the handset
§Menu§
¤
Settings
¤
Registration
¤
Register Handset
~
If required, enter the system
PIN for the base (the default is
0000 ) and press
§OK§
.
The display shows Handset is registering .
2) On the base
¤
Within 60 seconds, press and hold the
register/paging key on the base
(
¢
page 2) (for approx. 3 seconds).
1) On the handset
¤
Start to register the handset as
described in its user guide.
2) On the base
¤
Press and hold the register/paging key
on the base (
¢
page 2) (approx. 3 sec.).