Swisher HOBBY FARM PRO 22000, Owner'S Manual

Page: 17 / 38

• The adjustment Fins will let you fine tune the
spread pattern. Move the fins in the direction
that you want more material to be applied.(e.g.
If the material is spreading to heavy to the left
then move the Fins to the right for the spread to
become heavy on the right. See
FIGURE 17.1 .
•
Note: When you move
fins to the left this will
lessen the distance the
material is thrown.
When the fins are set
towards the Right this
will increase the
distance the material
is thrown.
• To adjust the fins, remove the wing nut and
carriage bolt that connected the Fin to the
Spinner Disc. The Fin should now be free to
pivot around the rear bolt.
• Adjust the Fin in the desired direction and
replace the carriage bolt and wingnut.
17
FIGURE 17.3
Spread Patterns
SPREAD PATTERN ADJUSTMENT
SPREAD PATTERN
• By positioning the Offset Adjustment Handle
detailed on
page 14,
you can set the spread
pattern. See Spread Patterns in
FIGURE 17.3
• Note: Due to the nature of using rotational
force to “throw” the material it is impossible
to completely eliminate material from
throwing in a certain direction. The use of
the Offset Handle will drastically reduce the
amount of material dispersed to one side.
• It’s recommended to do a couple test passes
with the desired material to see how it will react
when being dispersed. If needed you can fine
tune the spread pattern by gradually adjusting
the Offset Control Handle or using the
adjustable fin on the spinner disc.
FINE TUNING SPREAD PATTERN
• If you notice the spread pattern becomes
heavier or uneven to one side utilize the Offset
Handle to limit material flow to the heavy side.
• For example, if the material is flowing heavier
to the right side then move the Offset
Adjustment Handle slightly towards the “L”
Left. This will reduce material flow to right side
of the unit. The farther the handle is moved
away from “C” the more the flow is restricted.
FIGURE 17.1
FIGURE 17.2