Entrance Section - 14 bolts
flanged lip
flat lip
Exit Section - 13 bolts
loc nut
washer
washer
3/4" bolt
Fig. 1
A. ENTRANCE SECTION, AND 90°
SECTION
NOTES:
• At least two individuals are needed to assemble the
Twister Tube Slide.
• To aid in aligning holes when assembling sections,
insert a screwdriver through adjacent holes to maintain
hole alignment.
1.
Identify each slide section as either (1), (2), (3), (5), or
(6) as marked on the lip of each piece.
2.
Assemble entrance section using pieces (1) & (2), one
90° section using pieces (3) & (5). Join sections using
a 3/4" hex head bolt, two flat washers, and a loc nut
at each hole junction
(FIG. 1)
&
(Fig. 1a)
.
NOTE:
Fasten each loc nut finger tight until the entire slide is
assembled. Each time you join parts be sure each
flanged lip is mating with a flat lip.
NOTE:
Hand tighten the loc nuts only.
Fig. 1a
Twister Tube Assembly Instructions
6
