INSTALLING LEDGES
AND PLACEMENT OF WARNING LABELS
13
SCREW HOLE LOCATION GUIDE
Refer to the "Construction Close-ups" at the
beginning of these Instructions as indicated below:
12 ft.
ROUND
15 ft.
ROUND
18 ft.
ROUND
21 ft.
ROUND
24 ft.
ROUND
27 ft.
ROUND
30 ft.
ROUND
(4" Ledge/ 4" Vertical)
1
B & D
B & E
B & E
C & E
C & E
(6" Ext. Ledge/
6" Old Extruded Vertical)
1
A & D
A & D
A & D
A & D
A & E
A & E
A & D
A & D
A & E
A & E
FIG. A
(6" Ledge/ 6" Vertical)
1
E & C
E & C
E & C
E & B
E & B
E & B E & B
FIG. B
(6" Ledge/ 6" Vertical)
3
E & C
E & C
E & C
E & B
E & B
E & B E & B
FIG. C, D, E, G, H & I
(6” Ext. & 7" Ledge/ 6" Box Vertical)
2
A & D
A & D
A & D
A & E
A & E
A & E
A & E
FIG. F
(9" Ledge/ 8" Box Vertical)
2
A & C
A & C
A & C
A & D
A & D
A & D A & D
No. 12 x 1/2”
Sheet Metal
Screw
B
E
A
D
A
C
B
C
D
C D E
E D C
E
B
B
A
A
B
C
C
D
E
D E
B
1
2
3
Place ledges over the wall with each end
resting on a top plate. Using the above chart
Attention: You must use the 5/16” x 3/4” OD Stainless
as a guide align the set of holes in the top
Steel Washers with each Sheet Metal Screw to secure
plate as shown in the above drawing for your
the top ledges to the top plates. Failure to use the wash-
INSTALLING LEDGES ON BAR HARBOR
& RIO VISTA MODEL POOLS ONLY
size pool with the holes in the ledge and
ers may result in damaged ledges.
insert the No.12x1/2" Sheet Metal Screw
Place ledges over the wall with each
through the ledge and into the top plate.
end resting on a top plate. Align the
set of holes in the top plate as
The actual screw holes that are used does
shown in the instructions for your
not affect the integrity of the pool. You may
size pool with the holes in the ledge
use the set of holes that line up best!
and insert the No.12x1/2" Sheet
The ledge screws should not be tightened
Metal Screw through the washer
until all the ledges are in place and the
and the ledge and into the top plate.
pool has been filled with water.
Your pool is equipped with (3) three special
warning
ledges.
The (1) one ledge with a large
warning
on top is to be installed by the entry point
into the pool and is not to be obstructed by any object such as your ladder.
The (2) two ledges with the
warning
on the inside are to be placed opposite the
entry point into the pool with the warning facing the entry point.
THESE WARNINGS ARE NOT TO BE REMOVED
UNDER ANY CIRCUMSTANCES
NOTE:
Your pools top ledge was not designed to be a walk around.
Caution everyone who uses your pool
NOT TO WALK OR SIT ON THE LEDGE!
If your pool is equipped with feature tape it is best to apply it to the ledges at this time.
18
