MV-1001-1002-1044-09-2016 . Swim & Fun Scandinavia . [email protected] . www.swim-fun.com
© All rights reserved Swim & Fun Scandinavia ApS 2016
Page 51
•
Set the handle in position 2 ”Rinse”. This will cleanse the valve head from grit that would otherwise
end up in the pool.
•
Turn on the pump and let it run for about a minute while more water is led to the outflow.
•
Turn off the pump. et the handle to position 1 ”Filtration”
•
Turn on the pump. he filter system is now ready for use again.
Observe:
Keep in mind that the dirty return water should be easy to divert before the backwash
procedure starts – remember the backwash hose! Also, keep in mind not to interrupt
the backwash and the ensuing rinsing until they are completely carried out! Check in
advance that there is sufficient water in the pool to carry out these procedures.
7. User instructions for 7-way valve
The filtering system is equipped with a seven-way valve on the lid of the filter tank so that the
cleansing procedure can be controlled manually.
Press the handle down with the palm of your hand and turn it to the desired position. The following
working positions are possible:
1. FILTERING:
Water from the pool is pressed through the filter tank and pumped back to the
pool.
2. CLEANSING:
Water from the pool is pressed through the filter tank and is pumped back to an
external outflow. Grit in the overhead valve is cleansed.
3. CIRCULATION:
Water from the pool is returned to the pool without filtering.
4. BACKWASH:
Water from the pool is pressed through the filter tank and is pumped back to an
external outflow. Cleansing of dirty particles in the filter sand.
5. CLOSED:
All valve outlets are closed and the water cannot circulate. The lid can thereby be
lifted off the filter tank.
6. EMPTYING:
Water is sucked from the pool without filtering and is pumped to an external out
-
flow.
7. WINTER STORAGE:
This position is used when the sand filter and the pump have been emp
-
tied and detached from the pool and are kept frost-free during the winter. The position relieves
the pressure on the spring-loading and the overhead valve’s gasket.
Observe:
The seven-way handle on the filter tank’s overhead valve must NEVER be used in an
attempt to lift the filter tank!! The seven-way handle is not constructed for this purpose
and such an attempt may cause the handle to break!
Summary of Contents for ClearWater Pro 1002
