2
Stereoscopic microscopes are designed for viewing 3-dimensional objects, inspection or assembly of small
parts, and for dissection of biological specimen at low magnification. The 35° inclined viewing head provides
an upright, unreversed image which permits easy manipulation of object being viewed while looking through
the microscope. The incidental and transmitted illuminators incorporate high intensity 3 watt LED lamps.
For optimum viewing satisfaction, follow these simple procedures. Nomenclature used to describe
components and controls can be identified by referring to the diagram at left.
UNPACKING
Remove and unpack box containing post stand with 90mm diameter black/white contrast plate installed from
master carton, along with AC power cord. Remove and unpack box containing zoom head assembly, one pair
of eyepieces, 2 ea
ch rubber eyeshields, 0.90mm and 2mm “L” hex key wrench, 95mm frosted stage plate and
dust cover. .
1. Make certain not to touch any of the lens surfaces while handling the microscope. Dust, dirt, fingerprints
can damage the delicate lens surfaces or adversely affect image quality.
2. Examine packing material before you discard it. Retain the packing boxes in case you need to transport,
store, or return the microscope for service. If it becomes necessary to ship the microscope for any reason,
pack it in the original boxes and then pack these boxes in outer corrugated shipping container for optimum
protection. Use of the inadequate packing will not provide adequate protection in transit, and will void your
warranty.
ASSEMBLY
Place the microscope post stand on a flat stable and clean surface.
1. Mounting the focusing assembly to the microscope post stand.
A. Tighten support collar locking screw located on post stand.
B. Loosen focusing block locking screw locate on back of focusing block
C. Slide focusing block over 32mm diameter vertical post of stand
D. Tighten focusing block locking screw
2. Mounting stereo zoom head to stand.
A. Loosen head locking screw.
B. Insert head into the stand (do not force), positioning head to face either forward or backward,
whichever suits your preference or needs.
C. Tighten head locking screw.
3. Install rubber eyepiece shields over top of eyepieces.
4. Connect the coaxial plug, from incidental illuminator, into power jack located on top of 32mm diameter
post.
5. Plug your IEC power cable into the IEC port located on rear of microscope base and the other end of the
AC cord into appropriate 100 to 240 volt AC outlet.
