STEP 5
TOP FIXING
Tilt and hook headrail into bracket
at point (E). Rotate the headrail into
position until it clicks. To release the
headrail push the bracket at point (F)
SAFETY DEVICE
The safety device must be installed at
the maximum distance possible from
the control mechanism to prevent
looped chain becoming slack. Place
the safety device on the wall and
mark the positioning of the 1 screw
hole. Drill holes using a suitable
drill bit. Place device into position
ensuring the chain is fully taut.
RETAINING DEVICE
Screw the retaining device using
suitable fixings ensuring the device
is fully closed.
FACE FIXING
Hook the back of the headrail
into the bracket and rotate the
headrail into position. Secure
headrail by tightening the short
screw in the front of the bracket.
STEP 3
STEP 4
(E)
(F)
Short screw
ATTACHING
VERTICAL VANE
With the headrail fitted,
hook each fabric slat into
the headrail travellers
ensuring the traveller pegs
are in the open position.
BOTTOM WEIGHTS
Insert the bottom weights
into the vertical vane
bottom pockets.
STABILISING CHAIN
Push connector on
stabilising chain onto
the ear of each bottom
weight. Stabilising chain
should be connected to
both sides of the blind.
STEP 6
STEP 7
Tilt and hook headrail into front of
the bracket. Rotate the back of the
headrail into position until it clicks.
To release the headrail push the spring
clip towards wall and release at front.
MAX DISTANCE POSSIBLE
(ensuring chain is fully taut.)
