©2022 SwellPro All Rights Reserved
12
[13] Pitch Angle
[14] Flight Time
[15] Drone Latitude
[16] Drone Longitude
4
[17] Roll Angle
[18] Yaw Angle
[19] Remote controller Serial Number & Firmware
Version
[20] Flight Controller Serial Number
[21] Flight Controller Firmware Version
[22] Total Flight Time
[23] Joystick and Control Input
Install the Aircraft
Install Propellers
The SplashDrone 4 has two pairs of propellers - two clockwise propellers and two
counter-clockwise propellers. The hub of each motor shows the type of propeller used
for that motor. Propellers should not be attached to the wrong motors.
To install or remove propellers:
1. Check the propeller's marking (CW/CCW) to see if it
matches the motor. CCW propellers to CCW motors,
same for CW.
2. Place the propeller on the motor, rotate the propeller in
the hub for 1/8
th
of a turn until it engages.
3. Hold the arm of the aircraft tight with one of you hand.
4. Rotate the propellers in the direction indicated by the
lock signs with your other hand.
5. To remove the propeller, repeat steps 3&4.
4
If the signal to the drone is lost for any reason, the remote controller will display the last known location
of the drone.
