Swefog K1 HAZER, Owner'S Manual

Page: 16 / 28

16
RDM CONTROL (ANSI E1.20):
The machine can be controlled via a RDM ANSI E1.20 protocol. This is an intelligent bi-
directional communication using the standard DMX 512 link. The light console is able to
discover, read and configure the machine. The type of parameters and functions available
may be different depending on model configuration. Supported parameters:
RDM Parameter ID: Value: GET SET Default text / number:
allowed allowed
DISC_UNIQUE_BRANCH 0x0001
DISC_MUTE 0x0002
DISC_UN_MUTE 0x0003
QUEUED_MESSAGE 0x0020 YES No
STATUS_MESSAGES 0x0030 YES No E120_STS_LOW_FLUID, E120_STS_READY,
E120_STS_NOT_READY, E120_STS_OVERTEMP,
E120_STS_UNDERTEMP
STATUS_ID_DESCRIPTION 0x0031 YES No
SUPPORTED_PARAMETERS 0x0050 YES No
DEVICE_INFO 0x0060 YES No
PRODUCT_DETAIL_ID LIST 0x0070 YES No PRODUCT_DETAIL_FOGGER_GLYCOL
DEVICE_MODEL_DESCRIPTION 0x0080 YES No K1EU
MANUFACTURER_LABEL 0x0081 YES No Swefog
DEVICE_LABEL 0x0082 YES YES K1
SOFTWARE_VERSION_LABEL 0x00C0 YES No
BOOT_SOFTWARE_VERSION_ID 0x00C1 YES No Software ver ID, higher number = newer ver.
BOOT_SOFTWARE_VERSION_LABEL 0x00C2 YES No Human readable software version.
Higher number=newer ver.
DMX_PERSONALITY 0x00E0 YES YES select personality & see personality selected
DMX_PERSONALITY_DESCRIPTION 0x00E1 YES No Fog, Fan, Control *
* Control alternative enabled only if shutdown
over DMX is enabled, see system settings.
DMX_START_ADDRESS 0x00F0 YES YES
SENSOR_DEFINITION 0x0200 YES No &
SENSOR_VALUE 0x0201 YES No Values for above temperatures
IDENTIFY_DEVICE 0x1000 YES YES
MANUAL MODE:
•
Manual mode uses 3 tabs: Fog, fan, on/off.
•
Current fog output & fan speed is displayed in the main window with bars, independent
of what tab that is active. NOTE: Fan always runs at 10% at idle / fog off.
•
To set fog output: Activate Fog tab, set output 0-100% using ▲ / ▼ . Actual setting in %
is shown in display.
•
To set fan speed: Activate the Fan tab, set speed 11-100% using ▲ / ▼ . The actual
setting in % is shown on the display. NOTE: below 11%, fan speed = AUTO , and follows
fog output.
•
Fog on / off: Activate ON/OFF tab, press OK to start & stop fog production.
• NOTE: Fog production can be stopped in any tab by pressing X .